Filter
Top Products
Section 2. Installation
Page 2-6 PN 9001105 Rev. A SATO M-84PRO
5. If using roll labels (or tags), load the roll onto the
Label Supply Spindle so that the printing side of the
labels faces upwards as it unwinds from the roll.
The labels should be wound face-in. Push the roll
all the way to the inside of the printer and push the
Label Roll Retainer snugly against the outside of
the label roll.
6. If using fanfold labels (or tags) set them on a flat
surface behind the printer. Pass the labels (printing
side up) through the slot in the rear of the printer.
7. Make sure the labels are routed under the Label
Guide and through the Sensor Assembly.
8. Open the Label Hold-Down by squeezing the green
tab and the release tab together. The Label Hold
Down is spring loaded and will open automatically
when the latch is disengaged. Feed the labels under
the Label Guide, under the Label Hold Down,
through the Sensor Assembly and out the front of
the printer.
9. Inspect the label routing and verify that the path
matches that illustrated in the Label Loading
diagram. Set the Adjustable Label Guide to keep
the labels against the inside of the printer.
10. Close the Label Hold-Down by pushing downward
on the green tab until it latches closed.
NOTE: If the Label Dispenser option has been
purchased, see Appendix A, for proper
label routing instructions.
Label Roll
Label Roll Retainer
Print
Head
Label
Guid
e