Filter
Top Products
Section 2. Installation
SATO M-84PRO PN 9001105 Rev. A Page 2-7
11. Adjust the outside Label Edge Guide until it
touches the outside edge of the label and tighten the
thumb screw. Make sure the labels are also touching
the inside edge guides.
CAUTION: Using media narrower than the
maximum print width may cause excess
head wear due to the label edge. See page
2-9 for precautions.
12. If the ribbon is already loaded, close the Print Head
by rotating the black Head Latch toward the front of
the printer until it latches closed.
13. If the ribbon is not loaded, see the following
description for loading instructions.
14. Close both the Access Doors.
Route Labels
Under Guide
Label Hold Down
Inside Label Edge Guides
Sensor
Positioning
Sensor
Assembly
Head
Latch