Filter
Top Products
Section 3. Configuration
SATO M-84PRO PN 9001105 Rev. A Page 3-7
DEFAULT SETTINGS
SWITCH SELECTIONS
All switches are placed in the Off default position for shipping. This will result in the
following operating configuration:
SOFTWARE DEFAULT SETTINGS
The printer stores the software settings upon receipt and uses them until they are again
changed by receipt of a command containing a new setting. These settings are stored in non-
volatile memory and are not affected by powering the printer off. The printer may be reset to
use the default software settings by depressing the LINE and FEED keys simultaneously while
powering the printer on. This will result in the following default configuration:
Once the default operation is completed, a DEFAULT COMPLETED message will be
displayed on the LCD panel. The printer should be powered off while this message is being
displayed (or after the beep is heard. This saves the default settings in the non-volatile memory
where they will be automatically loaded the next time the printer is powered on.
Communications: 8 data bits, no parity, 1 Stop bit, 9600 Baud
Protocol: Ready/Busy
Sensor: Gap Sensor
Receive Buffer: Multi Job
Mode: Batch/continuous
Label Sensor: Sensor Used
Backfeed: Enabled
External Signals: Enabled
M-84PRO
Print Darkness 3
Print Speed 6 ips (3 ips for M-84PRO-6)
Print Reference Vertical = 0000, Horizontal = 0000
Zero No Slash
Print Offset +0
Ignore CR/LFDisabled
Character Pitch Proportional
Ignore CAN/DLE Disabled
Auto On Line Enabled
Feed on Error Enabled
Feed Reprint Disabled
Priority Command
Language English
CC1 Mem Select Card
Eurocode D5
H
DEFAULT COMPLETED