SATO M-84PRO Printer User Manual


 
Section 3. Configuration
SATO M-84PRO PN 9001105 Rev. A Page 3-23
REPRINT W/FEED
YES NO
This selection specifies whether or not the printer will print the
last printed label stored in memory when the FEED key is
pressed in the Normal Online mode.
1. Use the LINE key to step the cursor to desired setting. If Yes
is selected, the printer will reprint the last label when the
FEED key is pressed when the printer is Online. If the
printer is Offline, pressing the FEED key will feed a blank
label.
2. Once the setting is correct, pressing the FEED key will
accept the setting and advance to the
FORWARD/BACKFEED
DISTANCE DEFAULT
This display will only appear Backfeed is enabled (DSW3-4 =
OFF). The maximum backfeed distance is 255 mm.
1. Use the LINE key to select either the Default or the Manual
selection.
2. Once the setting is correct, pressing the FEED key will
accept the setting and advance to the next display.
FORWARD/BACKFEED
DISTANCE XXXmm
3. If Manual setting is selected, use the Cursor keys to
advance the distance to the desired setting. Each time the
LINE key is pressed, the Distance will advance 1 mm. The
maximum distance is 255 mm.
4. Once the desired distance is set, press the FEED key to
accept the setting and step to the next display.
EXT PIN 9 SELECT
MODE1 MODE2
This selection allows the user to select the conditions that cause
the signal on Pin 9 of the EXT connector to be true. If Mode1 is
selected, pin 9 will be true when the printer is ready to print, i.e. it
is Online and has a print job loaded (a quantity of labels to be
printed on the display). If Mode 2 is selected, pin 9 will be true if
the printer is Online.
1. Use the LINE key to step the cursor to the desired setting.
2. Once the desired setting is selected, press the FEED key to
accept the setting and step to the next display.
EURO CODE
D5
This selection allows the user to specify the dexadecimal code
for the character which is replaced with the Euro Character. The
default is D5H.
1. The cursor should be positioned over the first digit selection.
Use the LINE key to step to the desired setting.
2. Press the FEED key to advance the cursor to the second
digit of the desired hexadecimal code.
3. Press the LINE key to step to the desired setting.
4. When the setting is correct, press the FEED key to accept
the setting and step to the next display.