Filter
Top Products
Section 3. Configuration
Page 3-18 PN 9001105 Rev. A SATO M-84PRO
CARD->MEMORY
COPY COPYING
3. Press the FEED key to accept the selection. If Yes was
selected the copy process will start
CARD->MEMORYCOPY
COMPLETED
4. Once the copy process is completed, press the FEED key to
step the display.
CARD COPY/FORMAT
XXXXXXX ERROR
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory
available.
MEMORY->CARDCOPY
ALL <0MB> Y/N
This selection allows you to copy the entire contents of the
optional Expanded Memory to the PCMCIA Memory card
installed in the Memory Card slot on the rear of the printer.
1. Use the LINE key to step the cursor to desired setting. If Yes
is selected, the printer will enter the Card Copy mode. If No
is selected, the display will advance to the Card to Memory
Copy All mode.
COPY START
YES NO
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.
MEMORY->CARDCOPY
COPYING
3. Press the FEED key to accept the selection. If Yes was
selected the copy process will start
MEMORY->CARDCOPY
COMPLETED
4. Once the copy process is completed, press the FEED key to
step the display.
CARD COPY/FORMAT
XXXXXXX ERROR
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory
available.
CARD->MEMORYCOPY
PROGRAM Y/N
This selection allows the user to copy printer firmware from the
PCMCIA Memory Card to the printer.
1. Use the LINE key to step the cursor to desired setting. If Yes
is selected, the printer will enter the Card Copy mode. If No
is selected, the display will advance to the mode display.
COPY START
YES NO
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.