Filter
Top Products
281
10. Appendix
Installation, Move and Disposal of the
Machine
This section provides you with information about installation, move and dispos-
al of this machine.
Important
❒ Installation of this machine must be performed by an authorized dealer or
service representative. Never attempt to install the machine by yourself.
Machine Environment
If the machine is installed in an inappropriate location, you may not be able to
make copies or send or receive fax messages properly. Doing so may also cause
the machine to malfunction.
R
WARNING:
R
CAUTION:
Note
❒ Install the machine on a level surface. Make sure that the difference in height
is less than 2mm (0.08 in.) between the four corners of the machine.
❒ Install the machine on a stable surface. If you need to place it on a table, pre-
pare a sturdy table larger than the size of the machine exclusively for the ma-
chine.
❒ To avoid possible build-up of ozone, be sure to locate this machine in a large
well ventilated room that has an air turnover of more than 30m
3
/hr/person.
• Connect the power cord directly into a wall outlet and never use an ex-
tension cord.
• Turn off the power and disconnect the power plug (by pulling the plug,
not the cable) if any of the following occurs:
• You spill something into the machine.
• You suspect that your machine needs service or repair.
• The external housing of your machine has been damaged.
• Protect the machine from dampness or wet weather, such as rain and snow.
• Do not allow paper clips, staples, or other small metallic objects to fall inside
the machine.