Filter
Top Products
Specifications
297
10
Paper Size and Scanned Area
The part shaded will not be scanned, because it is outside the maximum scan-
ning width range.
Note
❒ Images at the edges of the original document (top 5mm (0.2 in.), bottom 4mm
(0.2 in.), left 4mm (0.2 in.), right 5mm (0.2 in.)) may not be scanned even if you
set a standard sized original properly.
❒ There may be some difference in size between the image scanned by your ma-
chine and the image printed at the receiving end.
❒ If the width of paper loaded in the other party's fax machine is smaller than
that of your original, your document image is automatically reduced to fit the
loaded paper at the time of transmission. See p.93 “Auto Reduction”
❒ When scanning an original, the machine detects the size of the original in the
following manner. When the original is set on the automatic document feeder
(ADF), the machine scans the original and if that original's width is less than
approximately 230mm (9.1 in.), it assumes that the original is 8
1
/
2
"×11" or
8
1
/
2
"×14" size width. And if the width is between 242mm (9.5 in.) and 261mm
(10.3 in.), it assumes the original to be B4 size, and 274mm (10.8 in.) or more,
11"×17" size width. The length of scanning range varies depending on this
size judgement, and the maximum is 600mm (23.6 in.).
4mm
(0.2")
4mm
(0.2")
5mm
(0.2")
5mm
(0.2")
Feeding direction
GFGYOM0N
Document width
148~304mm
(5.8"-12.0")
Document length
105~1,200mm
(4.1"-47.2")