Filter
Top Products
Key Operator Settings
188
7
How to Set User Parameters
This section describes how to set User
Parameters, using transmission mode
as an example. To change the trans-
mission mode from Memory Trans-
mission to Immediate Transmission,
you need to change the bit 6 of switch
00 from 0 to 1.
Important
❒ Do not change any bit switches
other than those listed in the previ-
ous section.
Note
❒ You can print the User Parameter
List to check the current settings.
However, only the items of much
importance or the items that you
often use are included in the list.
See p.189 “Printing the User Pa-
rameter List”.
A
AA
A
Press the {
{{
{User Tools}
}}
} key.
B
BB
B
Enter the code for "Key Op.
Tools" with the number keys.
Then press the {
{{
{q
qq
q}
}}
} key.
The "Key Op. Tools" main menu
appears.
C
CC
C
Enter the code for "System Set-
tings" with the number keys.
D
DD
D
Enter the code for "User Parame-
ters" with the number keys.
E
EE
E
Make sure that switch 00 is dis-
played.
Note
❒ To show other switches, press
[↑
↑↑
↑Switch] or [↓
↓↓
↓Switch].
F
FF
F
Press number key {
{{
{6}
}}
} to change
the value of bit 6 to 1.
Note
❒ Each time you press number
key {
{{
{6}
}}
}, the value switches be-
tween 1 and 0.
G
GG
G
Press [OK].