Filter
Top Products
8-28
CHAPTER8
Disabling of Stapler
This program is used to enable or disable the stapler of the optional
finisher (AR-FN3). If the stapler malfunctions, it can be disabled to
prevent further malfunction or possible damage to the stapler until it is
serviced.
To disable the stapler, press the check box of “DISABLING
OF STAPLER.” to display a check mark in the check box.
To enable the stapler, press the check box of this program
again to clear the check mark in the check box.
Disabling of Covers Mode
This program is used to prevent selection of the COVERS mode.
To disable the COVERS mode, press the check box of
“DISABLING OF COVERS MODE.” to display a check mark in
the check box.
To enable use of the mode, press the check box of this
program again to clear the check mark in the check box.
Prohibit Auto Paper Selection from the Bypass-Tray
This program is used to prevent automatic paper selection from the
bypass tray. In the default setting, auto paper selection from the
bypass tray is disabled.
To disable auto paper selection from the bypass tray, press
the check box of “PROHIBIT AUTO PAPER SELECTION
FROM THE BYPASS-TRAY.” to display a check mark in the
check box.
To restore this function, press the check box of this program
again to clear the check mark in the check box.
NOTE:
Auto paper selection from the bypass tray is available only when
Heavy Paper on the Bypass Tray program (see page 8-22) is not
set and Prohibit Auto Paper Selection from the Bypass-Tray
program is not set, either.
Disabling of PC/Modem Access
This program is used to determine whether persons other than
persons who know the key operator code number will be permitted
access via a computer or other equipment, either directly or through a
telephone line, to the copier’s key operator programs.
KEY OPERATOR PROGRAMS
KEY OPERATOR’S GUIDE
Key operator programs