Sharp AR-507 Copier User Manual


 
3-6
CHAPTER3
This copier has an edge erase mode and a centre erase mode.
Edge erase can be used to eliminate shadow lines around the edges of
copies caused when thick paper or a book is used as an original.
Centre erase can be used to eliminate the shadow produced by the
bindings of bound documents.
Edge + centre erase can be used to eliminate shadow lines around the
edges of copies and to eliminate the shadow at the centre of copies.
The standard erase width is 10mm (1/2"), but can be changed from 0mm
to 20 mm in 1mm increments (from 0" to1" in 1/8" increments).
KEY OPERATOR The initial setting of the width for edge erase and centre
erase can be changed. See page 8-18.
SPECIAL FUNCTIONS Erase
ERASE
A B
A B
A
A
A B
A B
Edge erase
1
Place the original in the document feeder tray or on the
document glass.
2
Press the SPECIAL MODES key.
The SPECIAL MODES screen will appear.
3
Press the “ERASE” key on the touch panel.
The setting screen for ERASE will appear.
READY TO COPY.
ERASE
EDGE ERASE
CENTRE ERASE
EDGE+CENTRE
ERASE
CANCEL
10
OK
OK
(0~20)
mm
READY TO CO
READY TO COPY.
SPECIAL MODES
MARGIN SHIFT
MULTI SHOT
PAMPHLET COPY
ERASE
COVERS
IMAGE EDIT
TEXT STAMP
TRANSPARENCY
INSERTS
DUAL PAGE
COPY
OK
AUTO
EXPOSURE PAPER SELECT
100%
COPY RATIO
AUTO 8/ 11
1
2
Edge + centre erase
READY TO COPY.
SPECIAL MODES
MARGIN SHIFT
MULTI SHOT
PAMPHLET COPY
ERASE
COVERS
IMAGE EDIT
TEXT STAMP
TRANSPARENCY
INSERTS
DUAL PAGE
COPY
OK
AUTO
EXPOSURE PAPER SELECT
100%
COPY RATIO
AUTO
A4
Centre erase