Filter
Top Products
Loading the Imaging Film
15
1. Installation
3
Take the new film out of its
package, and insert two of the
gears provided with the fax into the
ends of the spool with film. Make
sure that the two tabs on the gears
fit properly into the slots in the ends
of the spool.
•
Do not yet remove the band which
holds the spools together.
5
Cut the band which holds the
spools together with scissors, and
remove it. Insert the remaining
gear into the right end of the empty
spool and the flange into the left
end of the empty spool. Make sure
the tabs on the gear and the flange
fit into the slots in the ends of the
spool (the gear has two tabs and
the flange has one tab).
2 tabs
4
Hold the empty spool so that the
end with only one slot is on the left,
and lower the spools into the front
of the printing compartment. The
gears in the ends of the spool with
film should fit into the slots on each
side of the printing compartment.
1 tab
2 tabs
Flange
Gear
6
Pull the empty spool toward the
back of the compartment,
unwinding the film as you pull.
all-fo1530a.book Page 15 Tuesday, December 5, 2000 2:07 PM