Sharp XV-Z10000 Projector User Manual


 
Connections and Setup
-21
Connecting the Projector to a Computer
Optional
accessory
Connecting the Projector to Other Devices
DVI to 15-pin D-sub adaptor
Type: AN-A1DV (7.9" (20cm))
Connecting to a Computer
Using the the DVI to
15-pin D-sub Adaptor and
the RGB Cable
Connect the projector to the com-
puter using the DVI to 15-pin D-sub
adaptor and the RGB cable.
Secure the connectors by tightening the
thumbscrews.
Note
See page 84 “Computer Compatibility
Chart” for a list of computer signals com-
patible with the projector. Use with com-
puter signals other than those listed may
cause some of the functions not to work.
When connecting the projector to a com-
puter in this way, select “RGB” for “Signal
Type” in the “Options” menu, or select the
RGB mode by pressing
on the re-
mote control. See page 64.
A Macintosh adaptor may be required for
use with some Macintosh computers. Con-
tact your nearest Authorized SharpVision
Service Center or Dealer.
Depending on the computer you are us-
ing, an image may not be projected un-
less the signal output setting of the com-
puter is switched to the external output.
Refer to the computer operation manual
for switching the computer signal output
settings.
To RGB output terminal
Notebook computer
RGB Cable (commercially
available)
DVI to 15-pin D-sub adaptor
(sold separately)
XV-Z10000#Print#p21_22.p65 02.10.25, 7:27 PM21