Filter
Top Products
Image Projection
Basic Procedure
Connect the required external equipment to
the projector before operating the following
procedures.
Info
•
The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page
34
.
1 Plug the power cord into the
wall outlet.
• The power indicator illuminates red, and
the projector enters standby mode.
2 Press on the remote control
or
on the projector.
• The power indicator illuminates blue.
After the lamp replacement indicator il-
luminates, the projector is ready to start
operation.
Note
• The lamp replacement indicator il-
luminates, indicating the status of the
lamp.
Blue: The lamp is ready.
Blue blinking: The lamp is
warming up.
Red:
The lamp should be replaced.
• If the power is turned off and imme-
diately switched on again, the lamp
replacement indicator may take time
to illuminate.
• When controlling the projector using
RS-232C commands from a com-
puter, wait for at least 30 seconds
after the power has been turned on,
and then transmit the commands.
-32
Lamp
replacement
indicator
Power indicator
INPUT
button
Power (ON)
button
Power (OFF)
button
MENU button
", ',\, | buttons
ENTER
button
Power (ON)
button
INPUT
buttons
', ", \, |
buttons
MENU button
ENTER
button
Power (OFF)
button
XV-Z10000#Print#p31_39.p65 02.10.25, 7:29 PM32