Filter
Top Products
Basic Operation
-33
3 Press , , , or
on the remote control or on
the projector to select the IN-
PUT mode.
•
After pressing once on the projector,
use
to select the desired input mode.
Note
• When no signal is received, “NO
SIGNAL” will be displayed. When a
signal that the projector is not pre-
set to receive is received, “NOT
REG.” will be displayed.
• The INPUT mode is not displayed
when “OSD display” is set to “Level
A” or “Level B”. (See page 63.)
About the INPUT modes
"On-screen Display (Example)
Using RGB*
Using
Component
INPUT 2 mode
Using
Component
INPUT 1 mode
INPUT 3 mode
INPUT 4 mode
Using RGB*
➝
➝➝
➝
INPUT 5 mode
➝
* Input the RGB signal of the DTV, not
the computer.
Using S-Video
Using Video
Using Analog
RGB
The display varies accord-
ing to the “Signal Type” with
INPUT 5. The explanation
provided here uses the ex-
ample of the case of having
selected “Analog RGB”.
Used for projecting images
from equipment that sends
component signals or
RGB signals connected to
the INPUT 1 or 2 terminal.
Used for
projecting
im-
ages
from equipment
connected to the S-
VIDEO input terminal.
Used for projecting im-
ages from equipment
connected to the VIDEO
input terminal.
Used for projecting im-
ages from equipment
connected to the DVI in-
put terminal.
INPUT 1
INPUT 2
(
Compo-
nent
/RGB*
)
INPUT 3
(S-Video)
INPUT 4
(Video)
INPUT 5
(Digital PC
RGB/
Digital PC
Component/
Digital Video
RGB/Digital
Video
Component/
Analog RGB/
Analog
Component)
XV-Z10000#Print#p31_39.p65 02.10.25, 7:29 PM33