Filter
Top Products
Automatic Power Off
Function
When no input signal is detected for more than
15 minutes, the projector will automatically
turn off if set to “ON”.
The Auto Power Off function will be disabled
when it is set to “OFF”.
Select “Auto Power Off” in “Economy
Mode” under the “Options”
menu on the
menu screen.
➝For operating the menu screen, see
pages 40 to 43.
Note
• When the Auto Power Off function is set
to “ON”, 5 minutes before the power turns
off, the message “Power OFF in X min.”
will appear on the screen to indicate the
remaining minutes.
• “Auto Power Off” is switched on and off
by pressing
.
Selecting the Economy Mode
Selecting the Transmission Speed (RS-232C)
This menu allows you to adjust the transmission speed of the RS-232C connection by select-
ing the baud rate.
Selecting the Transmis-
sion Speed (RS-232C)
Select “RS-232C” in the “Options”
menu on the menu screen.
➝For operating the menu screen, see
pages 40 to 43.
Note
• Make sure that both the projector and
computer are set for the same baud rate.
Refer to the computer’s operation manual
for instructions for setting the computer’s
baud rate.
-68
XV-Z10000#Print#p66_68.p65 02.10.25, 7:32 PM68