Filter
Top Products
9
Part1
QUICK START GUIDE
Part2 Part3
Three new alkaline batteries LR6 (“AA”size) must be installed in the cash register to prevent the data and
user-programmed settings from being erased from the memory, when the AC cord is accidentally disconnected
or in case of power failure. Once installed, the batteries will last approximately one year before needing
replacement. At this time, the “ ” symbol will appear on the display to indicate the batteries are low and must
be replaced within two days. If the no battery symbol “” appears, you must install the batteries at once.
Do not set the mode switch to the , nor PGM positions while “” is being displayed.
Install three new alkaline batteries LR6 (“AA”size) according to the procedure shown below with the AC
cord connected and set the mode switch to the REG position:
1. Push the printer cover forward and detach it.
Be careful with the paper cutter, so as not to cut yourself.
2. Open the battery compartment cover next to the paper roll cradle.
3. Install three new alkaline batteries LR6 (“AA”size) as per the diagram.
When the batteries are properly installed “ ” on the display will disappear.
4. Close the battery compartment cover.
• Be sure to observe precautions shown on page 1 when handling
batteries.
• If you press a key by mistake, an error symbol “ ”
may be displayed. Press the
l
key to clear
the symbol after installing paper rolls.
“ ” or “ ” can be displayed only when the cash register is being turned on. Please be advised
that when the cash register is being turned off for a long time, the data in memory might be cleared
without the warning symbols: “ ” or “ ”.
2
Installing Batteries
A113_1 Quick Start Guide 06.9.11 6:35 PM Page 9