Filter
Top Products
7
Part1
QUICK START GUIDE
Part2 Part3
Operator display Customer display
(Pop-up type)
Amount: Appears in the far-right eight (max.) positions. When the amount is negative, the minus symbol “-”
appears before the amount.
Number of repeats for repetitive registrations:
The number of repeats is displayed, starting at “2” and incremental with each repeat. When you
have registered ten times, the display will show “0.”(2 → 3
.....
9 → 0 → 1 → 2
...
)
Receipt function status:
The indicator “_” appears in the RCPT OFF position when the receipt function is in the OFF
status.
Time: Appears in the second to sixth positions (using 24-hour format) in the OP X/Z, REG or MGR
mode. In the REG or MGR mode, press the
s
key to display the time.
Machine state symbols
: Appears during programming.
: Appears with an error code when an error is detected. For the details of error codes, please refer to
“Error code table” on page 31.
: Appears when the subtotal is displayed or when the amount tendered is smaller than the sales amount.
: Appears when the
V
key is pressed to calculate a subtotal in foreign currency.
: Appears when a transaction is finalized by pressing the
A
,
X
,
Y
,
c
or
b
key.
: Appears when the change due amount is displayed.
: Appears in the far-left three positions at the timing of key entry when the electronic journal (EJ) memory
is full. (Depending on programming.)
: Appears when the voltage of the installed batteries is under the required level. You must replace with
new ones within two days. Refer to page 76 for details.
: Appears when the batteries are not installed, or the installed batteries are dead. You must replace with
new ones immediately. Refer to page 76 for details.
: May appear right below the eighth and ninth places at the timing of finalization of a transaction when the
electronic journal (EJ) memory is nearly full.
Also appears right below the tenth place when power save mode is effective.
: Appears when programmed date (and time) for EURO modification operation has come.
: Appears when the print roller arm is not locked.
: Appears when the paper is not set or out.
This key locks and unlocks the drawer. To lock it, turn 90 degrees counterclockwise. To unlock it, turn 90
degrees clockwise.
PLU/SUB
DEPT REPEAT
RCPT
OFF
NUMBERSHIFTDC
Clerk code
5
Displays
6
Drawer Lock Key
A113_1 Quick Start Guide 06.9.11 6:35 PM Page 7