Filter
Top Products
77
Part3
FOR THE MANAGER
Part2Part1
Removing the paper roll
When a red dye appears on the paper roll, it is time to replace it. Replace the paper roll with a new one. If you
plan on not using the register for an extended period of time, remove the paper roll, and store it in an appropriate
place.
Caution: The paper cutter is mounted on the printer cover. Be careful not to cut yourself.
When not using the take-up spool (using as receipt paper):
1. Remove the printer cover.
2. Lift up the print roller release lever to unlock and open the print
roller arm.
3. Remove the paper roll from the paper roll cradle.
Do not pull the paper through the printer.
When using the take-up spool (using as journal paper):
1. Turn the mode switch to a position other than “ ” with the
power cord connected.
2. Remove the printer cover.
3. Press the
F
key to advance the journal paper until its printed
part is out of the way.
4. Cut the paper and remove the take-up spool.
5. Lift up the print roller release lever to unlock and open the print
roller arm.
6. Remove the paper roll from the paper roll cradle.
Do not pull the paper through the printer.
7. Remove the outer side of the take-up spool as shown
on the left.
8. Remove the printed journal roll from the take-up spool.
Installing the paper roll
For information on how to install paper rolls, refer to “Installing a Paper Roll” on page 10.
Caution: The paper cutter is mounted on the printer cover. Be careful not to cut yourself.
Area to cut
Print roller
release lever
Print roller arm
A113_3 FOR THE MANAGER 06.9.11 6:39 PM Page 77