Filter
Top Products
73
Part3
FOR THE MANAGER
Part2Part1
The details of the register system modification are as shown below:
A=1 A=2 A=3
Items (EURO status 1) (EURO status 2) (EURO status 3)
General Z1 report Issue Issue Issue
General Z2 report Issue Issue Issue
GT memories (GT1, GT2, GT3 and Training GT) - Clear Clear*1
Conversion of preset prices of Dept./PLU - Yes Yes*1
Conversion of entry digit/amount limit - Yes Yes*1
Exchange amount printing for total and change Yes Yes No
Exchange calculation method Division Multiplication Multiplication
Domestic currency symbol - [EURO] [EURO]
Domestic currency decimal point position - 2 2
Exchange currency symbol [EURO] Previous domestic currency -*2
symbol
Exchange currency decimal point position 2 Previous domestic currency -
decimal point position
Rounding system (Denmark/Sweden/Normal) - Normal Normal*1
Rounding up/down of the unit digits of amount - No No*1
Lowest digit entering limitation of item - Arbitrary Arbitrary*1
Lowest digit entering limitation of payment - Arbitrary Arbitrary*1
Memory of difference due to rounding - No No*1
Rounding of exchange currency Round off Round off Round off
(4 down/5 up)
• The item marked with “-” remains the same as the previous data.
*1: When you perform from EURO status 2, previous data remains unchanged.
*2: When you perform from EURO status 1 or 2, “space” is set.
IMPORTANT
• Conversion of the preset unit prices of departments and PLUs
Note that the conversion rate of the preset rate of the
V
key is applied for the conversion, and the method is
set to “division”. When the conversion is performed, the message “PRICE CONVERTED” will be printed on the
#800 report.
• After the execution of the procedure with “A=1”, treat EURO as foreign currency using the exchange key (
V
)
with the preset rate entry. Set the EURO conversion rate as the currency exchange rate for the exchange key.
• After the execution of the procedure with “A=2”, treat EURO as domestic currency, and national currency as
foreign currency using the exchange key (
V
) with the preset rate entry. Set the EURO conversion rate as the
currency exchange rate for the exchange key.
• As for the percent rate for
%
,
&
and
-
, the automatic conversion is not made. So, when your domestic
currency becomes EURO, you must change these settings so that they are based on EURO currency.
You can manually make these settings. For programming details, please refer to “EURO
Programming” section.
A113_3 FOR THE MANAGER 06.9.11 6:39 PM Page 73