Filter
Top Products
43
Part3 FOR THE MANAGER
PRIOR TO PROGRAMMING
Procedure for programming
1. Check to see whether a paper roll is present in the machine. If there is not enough
paper on a roll, replace it with a new one (refer to “Replacing the Paper Roll” on
page 76 for the replacement).
2. Put the manager key in the mode switch and turn it to the PGM position.
3. Program necessary items into the cash register.
Every time you program an item, the cash register will print the setting. Please refer to print samples in each
section.
4. If necessary, issue programming reports for your reference.
• On the key operation example shown in the programming details, numbers such as “22102007”
indicates the parameter which must be entered using the corresponding numeric keys.
• Asterisks in the tables shown in the programming details indicate default settings.
Entering character codes with numeric keys on the keyboard
For entering numerals, letters or symbols, enter a character code using numeric keys and press the numeric key
:
.
For the character codes, please refer to the alphanumeric character code table on the next page. By doing this,
you can program characters other than those on the key tops. For entering numerals and letters using character
keys, refer to “Using character keys on the keyboard” on page 14.
• Double-size characters can be made by entering the character code 253 or pressing the
W
key. “_” lights up
at the DC position of the display when double-size characters entry is selected as shown in the operator
display example below.
• All three digits of the character code MUST be entered (even if it starts with zero).
To program the word “SHARP” in double-size characters
253
:
083
:
072
:
065
:
082
:
080
:
S H A R P
REG
OPX/Z
MGR
PGM
X1/Z1
X2/Z2
A113_3 FOR THE MANAGER 06.9.11 6:39 PM Page 43