Filter
Top Products
19
Windows XP (64-bit) / Server 2003 (64-bit)
For A New XP (64-bit) / Server 2003 (64-bit) Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents
of the 64bit folder, found on the driver CD, onto a blank
floppy disk then follow the directions below.
1. Setup the RAID array prior to Windows installation.
2. Follow Microsoft procedure to install Windows
accordingly.
3. At the Windows Setup screen, press F6 to continue.
4. Insert the driver diskette that you made earlier.
Press S then press Enter.
5. Select Silicon Image SiI... Controller (64-bit
Extended) and press Enter.
6. Press Enter to continue and follow on-screen
instructions to complete the installation.
When Windows installation completes, go to SATARaid5
GUI on page 24 and install the RAID monitoring utility.
For Existing XP (64-bit) / Server 2003 (64-bit) Installation
1. Install the board and boot up Windows.
2. At the Found New Hardware Wizard:
For XP (w/SP1 or earlier)/Server 2003: go to step #3.
For XP (w/SP2 or later)/Server 2003 (w/ SP1 or later):
select No, not this time, then click Next.
3. Insert the driver CD, select Install the software
automatically (Recommended), then click Next.
4. Click Finish, remove the driver CD, shutdown
Windows, and setup your RAID array.
When Windows resumes, go to SATARaid5 GUI on
page 24 and install the RAID monitoring utility.