Filter
Top Products
7-9
ROUTING SWITCHER SYSTEM (E)
FANA, FANB : ROT/STOP
Displays whether the fan on the matrix board is rotating or
not.
FANn : ROT/STOP
Displays whether the fan of the main unit (except the
power supply unit) is rotating or not.
FRONT PANEL : BKS-R3400/INVALID
Displays whether the option switch is attached to the front
of the HDS-X3400 or not.
n
If the board (MAIN) to be inserted from the front is not
installed, the status of the rear connector board is not
displayed correctly.
Z : SET SDI FORMAT (HDS-X3000 Series)
Purpose
This menu is used to set the signal format for the output
board of the HDS-X3000 series (whether the signal is
reclocked in the HD-SDI or not) from the control terminal.
This setting becomes valid when the dip switch of the
RECLOCK BYPASS of the output board is turned off.
When the processor unit of HDS-X3000 series has the SD-
SDI output board (HKDS-X3050), the setting of the format
is not required.
Setting Procedure
1. Select the menu item “Z”.
2. Select the desired channel line using the cursor to be
set. (The HDS-X3400 will be switched in every four
channels, and the HDS-X3600/X3700 will be switched
in every eight channels.)
3. When [Enter] is pressed, the setting changes (“HD
SDI (RC)” ↔ “HD SDI (RC PASS)”).
4. Press [S] (Table Set), and the content now on display
is copied to the area of SDI FORMAT TABLE.
n
Unless pressing [S] (Table Set), the data will be
deleted when the power is turned off.
5. Press [Ctrl] _ [E] to stop the display and return to the
menu screen of the secondary station.
Example of Setting Screen (HDS-X3400)
7-3. Changed Menu (Secondary Station Setting Items)
SWITCHING FIELD FIELD
F1:FORMAT F2:FIELD S:Table Set Ctrl-E:RETURN TO MENU
DESTINATION UNIT
01 - 04 : HD SDI(RC)
05 - 08 : HD SDI(RC)
09 - 12 : HD SDI(RC)
13 - 16 : HD SDI(RC)
SOURCE UNIT
01 - 04 :
05 - 08 :
09 - 12 :
13 - 16 :
SELECT SDI FORMAT HDS-X3400 V1.00 STATION NUMBER 1