Filter
Top Products
43
Chapter 3 Basic Usage
Basic Settings
This section explains the steps required to configure the warning message
display, bar code, R-MIC and brightness of the LCD panel using the
Configuration Menu on the control panel.
Caution
There exist LIB-81 AIT library models without bar code or R-MIC readers.
Make sure that your library is equipped with a bar code and/or R-MIC reader
before modifying the “Barcode” or “R-MIC” setting. Modifying these settings
when using LIB-81 AIT library models that are not equipped with the
appropriate readers generates errors.
Note
For information about “Date & Time” of the Configuration Menu, refer to
“Setting the Date and Time” (page 22) in Chapter 2, “Installation”.
Disabling the Life Warning Display
When the device is shipped from the factory, the life warning is set to display.
This default setting is recommended. (Thus the following setup is unnecessary.)
Change this setting in “Warning” of the Configuration Menu.
Note
The displaying of the life warning can also be set through a browser.
1
At the status display, press the [MENU] button for two seconds.
2
Use the V and v buttons to select “5.Configuration”, then press the
[ENTER] button.
3
Select “2.Warning”, then press the
[ENTER] button.
4
Use the V and v buttons to select
“YES”, then press the [ENTER]
button.
The default factory setting is
“YES”.
Select “NO” to not display the warning.
5
When “[ENTER] to activate”
appears, press the [ENTER] button.
The life warning is now set.
The display returns to the menu.
6
Press the [CANCEL] button twice to return to the status display.
Configuration 12:34
1.Date & Time
2.Warning
3.Barcode
Warning
Enable YES
Warning
Enable YES
[ENTER] to activate