Filter
Top Products
99
Appendix
* Verify that the transport screw was removed from the Shipping position. t
“Unpacking” (page 13) in Chapter 2, “Installation”.
* • Verify that the bar code settings are correct. t “Setting the Bar Code” (page
44) in Chapter 3, “Basic Usage”.
• Verify that the bar code label is affixed properly. t “Preparing the
Cartridge” (page 25) in Chapter 2, “Installation”.
03050402 TableAxis The Position Sensor is not normal. (Origin
was not detected.)
03050501 TableAxis Destination not reached.
03050601 TableAxis Fine tuning not possible.
03060101 ShutterAxis Timeout occurred during Close Sensor High
Wait.
03060201 ShutterAxis Timeout occurred during Open Sensor High
Wait.
03060901 Shutter sensor malfunction.
Mechanical Control Errors
Error code Description
04000002 MechaCon Parameter is incorrect.
04000003 MechaCon Aborted.
04000004 MechaCon More than 8 tape volumes present.
Remove extra cartridges from the library.
04000005 MechaCon Cannot detect tape.
040000A0 MechaCon Element address is incorrect.
040000A1 MechaCon Element address does not exist.
AIT drive Errors:
Error code Description
06000001 The drive status is not normal.
06000002 The drive SCSI ID was not set properly.
06000061 The drive cannot load the cartridge.
Bar code Errors*:
Error code Description
07000001 A communication error occurred in the bar code reader.
07000002 A read error occurred in the bar code reader.
R-MIC Error:
Error code Description
08000001 Could not receive data from R-MIC.
08000002 Transfer failure due to internal parameter error.
08000003 Data from R-MIC incorrect.
08000004 An R-MIC error occurred.
08000005 Internal memory error.
Ethernet Error:
Error code Description
09000001 An Ethernet error occurred.
Mechanical Manager Error
(Byte2:Axis, Byte1:Class, Byte0:SubClass) (Continued)
Error code Description