Filter
Top Products
63
Chapter 5 Operating the AIT Drive
Cleaning the AIT Drive
When the AIT drive needs to be cleaned, the following message appears on the
LCD panel:
Clean the drive by setting the Cleaning cartridge (sold separately) in the AIT
drive. To set the cleaning cartridge, specify the slot and the AIT drive with an
element address. For information about element addresses, refer to “Assigned
Element Addresses” (page 48) in Chapter 3, “Basic Usage”.
There are four types of cleaning cartridges: the SDX5-CL for use with AIT-5
drives; SDX4-CL or SDX4-CLL for use with AIT-4 drives; SDX3X-CL for use
with AIT-3 Ex drives; and SDX1-CL for use with AIT-3, AIT-2, and AIT-1
drives. Make sure that you use the cleaning cartridge appropriate for your drive.
Note
First set the cleaning cartridge in the AIT library, then move it to the AIT drive.
Check in advance which slot is not occupied. For information about how to
check, refer to “Viewing Cartridge Information” (page 60) in Chapter 4,
“Operating the AIT Library”.
1
At the status display, press the [MENU] button for two seconds.
2
Use the V and v buttons to select “2.Eject/Insert”, then press the [ENTER]
button.
“Eject/Insert” appears.
3
Select “3.Insert Into Library”, then
press the [ENTER] button.
4
Select “1. Single Mode”, then press
the [ENTER] button.
5
Use the V and v buttons to set the
element address of the slot where
the cleaning cartridge is going to be
set, then press the [ENTER] button.
6
When “[ENTER] to activate”
appears, press the [ENTER] button.
Warning 12:34
Cleaning request
Eject/Insert 12:34
1.Eject From Library
2.Eject From Drive
3.Insert Into Library
Insert 12:34
1.Single Mode
2.Multiple Mode
Slot 01
Slot 01
[ENTER] to activate