Filter
Top Products
I-16
Connecting Devices
Chapter 2 Preparations
• When you are using a reference signal generator, and do
not want to perform loop-through output of the reference
signal input to one of the REF IN connectors of the unit,
attach a 75 Ω terminator to the other connector (see page
I-14). In addition, be sure to install termination resistors
of 75 Ω on each device connected to the unit. For details
on how to install the termination resistors, refer to the
operating instructions for each device.
• When the unit is connected to a device that cannot input
external reference signals, you can enable
synchronization by enabling the frame synchronizer
function of the SDI input connector connected to the
device (default: enabled). For details on configuration,
see the “Operating Instructions (
c Advanced Settings).”
This is always enabled for the VIDEO IN 1 to 3
connectors.
Turning the Unit On/Off
Turning the unit on
1
Connect the power cord (sold separately) to the AC IN
connector on the rear panel of the unit, and connect the
other end of the cord to an AC power supply.
2
Set the power switch to the ? position.
The unit turns on and starts up.
After startup is complete, a menu screen appears in the
menu display and the unit is ready for operations.
The [Misc] (miscellaneous) menu appears after startup
is complete.
3
Raise or lower the fader lever all the way up or down.
Turning the unit off
Set the power switch to the a position.
When you turn off the unit, the configurations for the
current effects, keys, and setup are not saved. To save the
current configurations, perform [Startup Define] in the
[Setup] menu.
For details on this operation, see “Saving Settings” (page I-35).
Notes
Tip
Power switch
Note
Fader lever