Filter
Top Products
I-32
Mixing Audio
Chapter 3 Basic Operations
12
Turn the V1 knob to select [Auto Adjust Execute], and
press the V4 knob.
Auto chroma keying is executed using the color
specified with the sample mark as a reference signal,
and the composed image is output in the PVW area.
After the auto chroma keying is executed, the sample
mark disappears automatically.
13
Execute the transition.
The image of the PST/KEY cross-point button is
superimposed on the program video output.
You can also configure the duration for video composition (transition
rate). For details on configuration, see the “Configuring the Transition
Rate” (page I-27).
Chroma key settings can be saved as “snapshots” and recalled when
necessary. For details, see “Snapshots” (page I-34).
Mixing Audio
Mix audio that is input to the unit, and output the final
audio (i.e., program output) from the PGM OUT connector
of the audio output block.
Input signals must be assigned to the channel faders (1 to 6) in the audio
control block beforehand. For details on configuration, see “Assigning
Audio Input Signals to the Channel Faders” (page I-21).
1
In the audio control block, press the CH ON buttons
for the channels to which the audio signals you want to
mix are assigned to light them.
The button lights green or turns off with each press.
CH ON button status
2
Adjust the audio levels using each channel fader to
perform mixing.
3
Use the program fader to adjust the audio level of the
program output.
If the peak indicators light red or the input signal indicators do not
light, see “Configuring the Mic/Line Levels for Audio Inputs” (page
I-22) and adjust the mic/line levels.
Tip
0001
Rate
30
SS
Mon
PGM
Auto Chromakey
3/3
Select
Start
Back
Sample Mark
Sample Mark Adjust
Auto Adjust Execute
Enter
Button status Meaning
Lit green On Audio is output
Not lit Off (default) Audio disabled
1
23