Filter
Top Products
About Power Connections
113
The VAIO computer does not resume
from Standby or Hibernate mode
❑ Verify that the computer, server and network settings are configured
correctly. See the section, “Configuring RoomLink” on page 57.
❑ Check the following, if applicable to your connection environment:
❑ A crossover cable is securely connected between RoomLink™ and a
single VAIO computer.
❑ The network switch or the router device is turned on. (See the
information supplied with your network switch or router device, for
details.)
❑ The router device is turned on before turning on the network media
receiver.
❑ The network media receiver, network switch, or router device are
properly connected using the appropriate network cables
*
.
❑ If using a router device, RoomLink™ and the VAIO computer have
been configured to obtain the IP address automatically.
❑ Verify that the correct server name appears in the Select a server
screen. (The Select a server screen lists all current and previous servers
connected to RoomLink).
❑ When connecting to RoomLink™ for the first time, the network media
receiver does not automatically bring a VAIO® computer out of Standby
mode. Subsequent connections bring your VAIO computer out of Standby
mode.
❑ RoomLink cannot automatically resume the functions of certain VAIO
computers due to computer settings or the network environment. The
automatic resume feature is not available for VAIO notebook computer
models or for VAIO computers that use a wireless LAN connection. This
Resume feature is available for wired networks only.
* Use network cables that support 100BASE-TX.
✍ The connected server history is lost when the AC power cable is disconnected. All
settings except for the IP address are lost.