Filter
Top Products
Setting Up RoomLink
67
Updating RoomLink firmware
The network media receiver enables you to use your VAIO® computer to update
RoomLink™ firmware.
1 On the Remote Commander, press the MAIN MENU button.
The Main Menu appears.
2 Highlight Settings, then press the SELECT button.
The Settings screen appears.
3 Press the up or down arrow buttons to highlight System Settings, then press
the SELECT button.
The System Settings screen appears.
4 Press the up or down arrow buttons to highlight Firmware update, then
press the SELECT button.
The Firmware Update screen appears.
✍ Check the Sony Computing Support Web site at http://www.sony.com/pcsupport, for
future firmware updates.
Firmware Update screen
Settings
Firmware Update
OK Cancel
!! IMPORTANT !!
Once the update starts, the operation cannot be canceled.
It takes a few minutes to complete the update. Please wait
until the device returns to standby mode. The remote
commander is disabled until the update is complete. If the
power is turned off during the update process, the device
may become disabled.
Start system software update.
SELECT
:Select
RETURN
:Return