Sony PCNA-MR10 Network Card User Manual


 
RoomLink User Guide
30
Setting up the Remote Commander unit
1 Open the battery cover on the back of the Remote Commander® unit.
2 Insert two AA batteries (supplied) by matching the + and - on the batteries,
with the diagram inside the battery compartment.
To program the Remote Commander
Your Remote Commander® unit is preprogrammed to control certain TVs. Refer
to your TV manufacturer’s code table for more information. The Remote
Commander may not be compatible with some TV models, even when the
appropriate TV manufacturer code is entered.
1 Press and hold the SELECT button.
2 Enter your TV code number, using the channel number buttons.
3 Release the SELECT button after you have entered the TV code number.
Inserting batteries into the Remote Commander
Under normal use, the AA batteries may last up to six months. If your Remote
Commander does not operate properly, the batteries may need replacing. If your
Remote Commander is not being used for long periods of time, remove the batteries
to avoid possible damage from leaking batteries.
After replacing the batteries in your Remote Commander, the TV manufacturers code
may require resetting. Reset the code each time you replace the batteries.