Filter
Top Products
1-10
VPL-CS2/CX1
GB
18
Connecting the Projector
When you use a PS/2 mouse port
To connect a Macintosh computer
Use an ADP-20 signal adapter (not supplied). In this case, however, you can
not control the mouse of the computer by the Remote Commander.
This section describes how to connect the projector to a VCR and 15k RGB/
component equipment.
For more information, refer to the instruction manuals of the equipment you
are connecting.
To connect a VCR
Connecting with a VCR or 15k RGB/Component Equipment
INPUT A
S VIDEO
VIDEOMOUSE
AUDIO
to audio output
Rear side
HD D-sub
15-pin cable
(supplied)
to mouse port (PS/2)
PS/2 Mouse cable (supplied)
Stereo audio connecting cable (not supplied)
to monitor output
Computer
INPUT A
S VIDEO
VIDEOMOUSE
AUDIO
Video cable
(not supplied)
Stereo audio
connecting
cable (not
supplied)
S-Video cable (not supplied)
VCR
to video output
to S video output
Rear side
to audio output
19
GB
Connecting the Projector
Setting Up and Projecting
To connect a 15k RGB/Component equipment
. S
et the aspect ratio using ASPECT in the INPUT SETTING menu
according to the input signal.
.
When
you connect the unit to 15k RGB/component video equipment,
select RGB or component with the INPUT-A setting in the SET
SETTING menu.
.
U
se the composite sync signal when you input the external sync signal
from 15k RGB/component equipment.
Notes
INPUT A
S VIDEO
VIDEOMOUSE
AUDIO
Rear side
Stereo audio connecting cable (not supplied)
SMF-402 Signal Cable
(not supplied)
3 x phono jack ↔ HD D-sub
15-pin (male)
to audio
output
15k RGB/Component equipment
to RGB/
component
output