Filter
Top Products
21
First steps
Gigaset SE366 WLAN / englisch / A31008-M1063-R101-4x-7619 / device.fm / 13.11.2008
Schablone 2004_12_27
Reset
The reset button is located behind the small opening labelled Reset.
u Reboot function (software reset): Press the button for longer than 1 second but less
than 5 seconds to reboot the device. This does not affect the configuration settings.
u Reset function (returns to factory settings): Press and hold the button for at least
5 seconds to return all settings to the factory settings.
Warning: This will clear all the configuration settings you have made since the initial
startup. This also applies for the data generated with WPS for the wireless network
(SSID and pre-shared key).
Setting up the Gigaset SE366 WLAN
The Gigaset SE366 WLAN can be set up in any suitable location in your home or office.
You do not need any special wiring. However you should comply with the following
guidelines:
u Place the device away from heat sources, direct sunlight and other electrical devices.
u Do not place the device on a heat-sensitive surface.
u Do not place objects on the device. Ensure that all air openings for air circulation are
not blocked.
u Lay the cables so that nobody can trip over them.
u Position the device on a non-slip surface.
u A suitable socket as well as a connection to the Ethernet interface of a PC or a wired
network must be available in the place where you set up the Gigaset SE366 WLAN.
u Do not position the device in the immediate vicinity of stereo equipment, TV sets or
microwave ovens. This may cause interference.
u For wall mounting: Make sure not to damage any pipes or cables in the wall when
drilling the dowel holes.
WAN Socket for connecting to the DSL modem.
LAN4 – LAN1 Four 10/100 Mbps switch ports with automatic recognition (RJ45).
You can connect up to four Ethernet devices (such as PCs, a Hub
or Switch).
Element Description