Filter
Top Products
21
Connecting the Projector
Chapter 2 Preparations
Select “RGB” in “Signal Mode” of “Input Source” in the
PICTURE CONTROL window.
For details, see page 27.
Connecting with HD-SDI Equipment
Attach the optional LKRI-002 HD-SDI (4:2:2) or LKRI-
003 HD-SDI (4:4:4) input board to the input board
attachment part, and connect the HDCAM recorder/player.
The illustration below shows an example with the LKRI-
002 attached on INPUT B.
When the LKRI-003 is attached to the projector, select the
type of signal with “Signal Mode” of “Input Source” in the
PICTURE CONTROL window. For Single-link input,
select “YPbPr” or “YPbPr FULL”. For Dual-link input,
select “RGB” or “RGB FULL”.
For details, see page 27.
Connecting with Component/Video
GBR Equipment
Attach the optional LKRI-001 analog input board to the
input board attachment part on the projector, and connect
with a DVD recorder/player or analog video equipment
equipped with the component output, or an high-definition
equipment equipped with a video GBR connector.
When connecting to the output of HD component
equipment, set “Signal Mode” of “Input Source” in the
PICTURE CONTROL window to “YPbPr”, and when
connecting to the output of HD video GBR equipment, set
to “RGB”.
For details, see page 27.
Note
Note
SRW-5000
HD DIGITAL VIDEO CASSETTE RECORDER
INTER LOCK
ETHERNET RS232C
IN OUT
AUXDVI-D
IN connector
HD-SDI connecting cable
(not supplied)
HDCAM recorder/player, etc.
Left side
to HD-SDI output
Note
R(Pr/Cr)B(Pb/Cb)HD VDG(Y/Y)
IN
INTER LOCK
ETHERNET RS232C
OUT
IN OUT
AUXDVI-D
R/Pr / G/Y / B/Pb
connectors
Component cable, etc
(not supplied)
Betacam, DVD recorder/player, etc.
Left side
to component output/
video GBR