Sony SRX-T110 Projector User Manual


 
30
INSTALLATION Window
Chapter 4 Adjustments and Settings Using the SRX Controller
6500K: White (0.3127, 0.3290)
9300K: White (0.2840, 0.2970)
DCI W/P: White (0.3140, 0.3510)
CUSTOM1 to CUSTOM3: White (0.3127, 0.3290)
(default values)
Gamma settings
2.6: 2.6
2.2: 2.2
CUSTOM: Value set using CUSTOM
Frame Adjust
Adjusts the horizontal size and the position of the picture.
Clicking increases the setting value, and
decreases it.
Clicking the “RESET” button resets all the settings of
“Frame Adjust” to the factory-preset values.
Dot Phase: Adjusts the phase of the SXRD panels and the
input signal. Adjust the value to obtain the clearest
picture.
H Size: Adjusts the horizontal size of the picture according
to the input signal. As the setting value increases, the
horizontal size of the picture becomes larger.
H Shift: Adjusts the horizontal position of the picture. As
the setting value increases, the picture moves to the
right. As the value decreases, the picture moves to the
left.
V Shift: Adjusts the vertical position of the picture. As the
setting value increases, the picture moves up. As the
value decreases, the picture moves down.
Adjustment of “Dot Phase” and “H Size” is available
only for analog RGB signals input from a computer.
If the position of the picture is not adjusted correctly,
noise may appear in the blank portion of the screen. This
is not a malfunction of the projector. Adjust the picture
position correctly with “Frame Adjust”.
INSTALLATION Window
The INSTALLATION window is used to adjust the
projected picture and to change the lamp output, etc.
LENS CONTROL
Adjusts the projected picture on the screen.
Zoom +/–: Adjusts the size of the picture. Clicking
enlarges the picture size, and reduces the picture
size.
Focus +/–: Adjusts the picture focus. Clicking focuses
on a picture further back. Clicking focuses on a
forward picture.
Shift +/–: Adjusts the vertical position of the picture.
Clicking moves the picture upward. Clicking
moves it downward.
ELECTRIC V SHIFT FUNCTION
Adjusts the vertical position of the projected pictures
electrically. As the setting value increases, the picture
moves upward. As the setting value decreases, the picture
moves downward.
Clicking the “RESET” button resets the setting to the
factory-preset values.
This function is effective in the following cases:
- When single-screen mode is selected
- When quad-screen mode is selected and
“PROGRESSIVE DISPLAY MODE” is set to “On”
When this function is used for quad-screen mode, all the
projected signals should be genlocked to synchronize
with each other with a phase difference of less than 5
µsec. If they are not synchronized, the picture is not
displayed correctly.
Notes
Notes