Sony SRX-T110 Projector User Manual


 
35
Troubleshooting
Chapter 5 Others
Troubleshooting
If the projector appears to be operating erratically, try to diagnose and correct the problem using the following guide. If
the problem still persists, consult your Sony dealer.
Power
Picture
Remote Commander/SRX Controller
Symptom Cause Remedy
Power is not turned on. The main power is turned off. Set the power switch on the projector to the upper position (page
22).
The projector and a computer for
controlling the projector are disconnected.
Connect the projector and a computer properly (page 17).
The cooling unit is detached. Consult your Sony dealer.
Symptom Cause Remedy
No picture. Cables are disconnected. Check that the proper connection has been made (page 20).
Input selection is not correct. Select the input source correctly in the SCREEN CONTROL
window (page 24).
The picture is cut off. Click the “OFF” button of “MUTING” (page 25) or the “OFF”
button of “CUT OFF” (page 25) in the SCREEN CONTROL
window, or press the MUTING button on the Remote Commander
(page 23).
Ambient temperature is high. Reduce the room temperature so that it becomes within the
operating temperature (5–35°C).
Color balance is incorrect. Incorrect input source mode is selected. Set “Signal Mode” of “Input Source” in the PICTURE CONTROL
window correctly (page 27).
The picture is too dark. Contrast and brightness has not been
adjusted properly.
Adjust the “Contrast” or “Brightness” in the PICTURE
CONTROL window (page 28), or adjust them using the CONTR
or BRIGHT button on the Remote Commander (page 11).
Lamp mode is not properly selected. Set “LAMP POWER” or “LAMP SELECT” in the
INSTALLATION window correctly (page 31).
On-screen display does
not appear.
OSD OFF button has been clicked. Click the “ON” button of “OSD” in the SCREEN CONTROL
window (page 10).
A line appears in the
center of a projected 4K
image.
The input signal is not suitable to be
projected as a 4K image.
Check that the signal can be projected as a 4K image (page 25).
Symptom Cause Remedy
The SRX Controller does
not appear.
The projector and a computer for
controlling the projector are disconnected.
Check that the proper connection between the projector and a
computer has been made (page 17).
The Remote Commander
does not work.
The remote control detector has been
removed.
Consult your Sony dealer.
The batteries are dead. Replace with new batteries (page 12).