Filter
Top Products
Programmer's Guide PcOS Series 150 Configuration Mode
12/14/99 Rev G Page 97
General Recommendation
10 cpi The 10 cpi command can be prevented from being acted on.
If set to disable, the printer will ignore the 10 cpi command
(DC2).
Active
Disabled
Print Illegal
Commands
No
Yes
Print Zone There are two print zone settings.
Normal (2.40 inch)
Wide (2.83 inch)
Series 50
Compatibility
The Ithaca Series 50 Printer uses several commands that are
not supported by the Series 150 Printer. In some cases, these
commands have different functions in the Series 150 Printer.
If this option is set, the Series 50 commands are activated
and overlapping Series 150 commands deactivated.
Off
On
Vertical
Control
Line Spacing The line spacing can be defaulted to 6 or 8 lpi.
6 lpi
8 lpi
Auto Line
Feed
An auto line feed feature can be set as a default where all
[CR]’s will have a [LF] added. If auto line feed is set to on,
this feature is activated.
Off
On
Auto Carriage
Return
An auto carriage return feature can be set as a default where
all [LF]’s will have a [CR] added. If auto carriage return is set
to on, this feature is activated.
Off
On
Form Length The default form length can be set from 3 to 17 inches. This
configuration affects how the [FF] command operates.
3 to 17 inches 11
Line Feeds
Before Cut
The number of line feeds before a cut operation is performed
can be set from 0 to 15 lines.
0 to 15 lines 0
Character
Print Mode The default print mode can be set to Draft, Utility, NLQ
Courier, or NLQ Sans Serif. In most cases, Draft or Utility
mode will be the default selections.
Draft
Utility
NLQ Courier
NLQ Sans Serif
Character
Pitch
The default print pitch can be set to 8, 10, 12, 15, 17.1, 20, or
24 characters per inch.
8 cpi
10 cpi
12 cpi
15 cpi
17.1 cpi
20 cpi
24 cpi