Filter
Top Products
Control Codes PcOS Series 150 Programmer's Guide
STAR Codes
Page 78 Rev G 12/14/99
Control codes used for graphic printing
[ESC] 1 Set 7/72-inch line feed.
[ESC] A Define n/72-inch line feed.
[ESC] 2 Set n/72-inch line feed.
[ESC] J <n> Set one-time line feed of n/72-inch.
[ESC] z 0 Set 1/12-inch line feed.
[ESC] K <n1> <0> Set 8-dot single-density bit image.
[ESC] L <n1> <n2> Set 8-dot double-density bit image.
[ESC] h 1 Select vertical expanded character mode.
[ESC] h 0 Cancel vertical expanded character mode.
Control codes used for peripheral units
[BEL] Defer drive command for Peripheral Unit 1.
[EM] Set immediate drive command for Peripheral Unit 2.
[FS] Set immediate drive command for Peripheral Unit 1.
[SUB] Set immediate drive command for Peripheral Unit 2.
Other control codes
[RS]
Activate sound buzzer.
11
[CAN] Cancel print data in buffer.
[ESC] U 1 Select unidirectional print mode.
[ESC] U 0 Select bidirectional print mode.
[ESC] @ Initialize printer.
[ESC] ! * End italics.
[ENQ] Perform inquiry.
[ESC] d 0
Cycle autocutter.
12
[ESC] d 1 Cycle autocutter.
[ESC] W 1 Select expanded character mode.
[ESC] W 0 Cancel expanded character mode.
[ESC] y <n> Set n/144-inch line feed.
[ESC] 3 <n> Set n/216-inch line feed.
11
This command only functions if the internal buzzer option was installed at the factory.
12
The printer can be equipped with either a full or partial cutter option.