Filter
Top Products
Programmer's Guide PcOS Series 150 Control Codes
NCR2567 Codes
12/14/99 Rev G Page 79
NCR2567 Codes
This section lists the NCR codes that are supported by the PcOS Series 150 Printer. Ithaca Peripherals
has no control over how NCR extends or changes these control codes. Ithaca Peripherals makes no
guarantees as to the operation of its printer when it replaces an NCR printer. The NCR emulation is
intended to make it as easy as possible to replace an NCR printer with a Series 150 Printer.
The following section lists the NCR commands that are processed. They are as close as possible to
NCR printers. The user must remember that the Series 150 Printer is not designed as a drop-in
replacement for an NCR printer. The PcOS Series 150 Printer is designed to bring new and unique
features and functionalities to a POS receipt/validation printer.
NCR Command Summary
Please refer to the NCR Information Manual for field definitions. The following is a list of the
NCR commands that are supported.
Command Description
[ENQ] Send status byte to host.
[BEL] Open Cash Drawer 1.
[BS] Open Cash Drawer 1.
[LF] Set line feed.
[FF] Advance form one line.
[SO] Set one-line double-wide mode.
[SI] Cancel double-wide command.
[DLE] Clear all printer and interface functions.
[DC1] Deactivate all option drivers.
[DC2] Set one-line double-wide alternate command.
[DC3] Cancel double-wide alternate command.
[DC4] n Set paper feed n lines.
[NAK] n Feed n dot rows after each print line.
[SYN] n Set number of dot rows fed after each print line.
[ETB] Print buffer contents; advance one line.
[CAN] Perform validation open assembly.
[EM] Perform knife cut.
[SUB] Perform knife cut.
[GS] Close platen when form is present.
[RS] Close platen when form is present.