Filter
Top Products
Print 24bit hex-density graphics
Mode ASCII
Decimal Hexadecimal
< FS >
“2” nl n2 28 90 nl ni’ 1C 5A nl n2
Both
ml m2 m3 ___ ml m2 m3 ml m2 m3 ___
Prints 24-bit dot graphics at 360 dots per inch horizontally. The graphic
image is 24 dots high and nl + nZ x 256 dots wide. Maximum width is
8 inches (2880 dots). In the data ml, m2, m3 . . . each three bytes represent
24 vertical dots. In the leftmost position, the most significant bit of ml
is the top dot; the least significant bit of ml is the eighth dot from the
top: the most significant bit of m2 is the ninth dot; the least significant
bit of m2 is the sixteenth dot from the top; the most significant bit of
m3 is the seventeenth dot from the top; the least significant bit of m3 is
the bottom dot. The rest of the data is similar. The number of data bytes
must be 3 x (n/ + n2 x 256). Dots beyond the right margin are ignored.
At the end of dot graphics printing the printer returns automatically to
character mode.
Select graphics mode
Mode ASCII
Decimal Hexadecimal
< ESC > “*”
n0 nl 27 42 n0 nl 1B 2A n0 nI
Both
ti2 ml m2 _._ n2 ml m? n2 ml m2 _._
Selects one of eleven graphics modes depending on the value of n0 and
prints dot graphics in this mode. See < ESC > “K” (for 8-bit graphics)
or < FS > “2” (for 24-bit graphics) for information on nl, n2, ml, m2,
.
n0
0
1
2
3
4
6
32
33
38
39
40
Graphics mode
8-bit Single-density ( 60 dots per inch)
b-bit Double-density
(120 dots per inch)
8-bit Double-density, double-speed
8-bit Quadruple-density
(240 dots per inch)
8-bit CRT graphics, mode I ( 80 dots per inch)
8-bit CRT graphics, mode II ( 90 dots per inch) I
24-bit Single-density ( 60 dots per inch)
24-bit Double-density (120 dots per inch)
24-bit CRT graphics. ( 90 dots per inch)
24-bit Tripple-density
(180 dots per inch)
24-bit Hex-density (360 dots per inch)
80