Filter
Top Products
Chapter 4 Configuring, Managing and Maintaining the Server Using the Web-Based Interface 33
■ 01h - Temperature
■ 02h - Voltage
■ 04h - Voltage
■ 07h - Processor
■ 0Ch - Memory
6. Select the action for the alerts by selecting the check boxes in the Event Action
Configuration section.
If you are selecting a power control action, select the action from the drop-down
list after selecting the Power Control check box.
In the example shown in
FIGURE 4-2, the system is configured to enable all
actions. A filter has been created to filter fan alerts. When an alert occurs, the
system will cycle power, send an alert to the SEL, and send mail to the addresses
listed in the E-mail Notification screen (see “Configuring E-mail Notification” on
page 30). You can configure up to six filters.
7. Click Submit to create the filter.
Configuring System Management Access
The System Management Access submenus allow you to set up the SSL certificate
and SNMP. The SSL configuration is used for creating certificates required in the
Certificate Signing Request (CSR). The certificate is required to enable encryption for
when you use HTTPS for secure web browser access. HTTPS requires a digitally
signed certificate to be installed at the applicant’s site. The SNMP screen allows the
configuration of SNMP settings, communities, and users.
▼ To access the System Management Access
Submenus
● From the Configuration submenu click the System Management Access tab.
The System Management Access submenu tabs appear.