Filter
Top Products
Chapter 7 Using the Command-Line Interface 83
▼ To Configure the Event Filter Tables
1. To configure a PEF EventFilterTable target, enter the following commands:
–> cd /SP/AgentInfo/PEF
/SP/AgentInfo/PEF –> show
The result of executing the show command appears:
By examining the output of the show command, you can view the current global
control configuration. If necessary use the cd and show commands to navigate to
and examine the individual event filter table targets. You will need to decide
which table you are going to configure.
2. When you have decided which EventFilterTable to configure, enable the table
by entering the following commands:
Note – This example uses EventFilterTable1.
/SP/AgentInfo/PEF –> cd EventFilterTable1
/SP/AgentInfo/PEF/EventFilterTable1–> set status=enable
/SP/AgentInfo/PEF
Targets:
EventFilterTable1
EventFilterTable2
EventFilterTable3
EventFilterTable4
EventFilterTable5
EventFilterTable6
Properties:
PEFGlobalCtrl = enable
PEFActionGlobalCtrlPowerOff = enable
PEFActionGlobalCtrlPowerCycle = enable
PEFActionGlobalCtrlPowerReset = enable
PEFActionGlobalCtrlAlert = enable
PEFActionGlobalCtrlMail = enable
PEFActionGlobalCtrlInterrupt = enable
Target Commands:
show
cd
set