Filter
Top Products
4-16
C2SBA+II/C2SBA+/C2SBA/C2SBE User's Manual
Latency Timer
This setting allows you to set the clock rate for the bus master. A high-priority,
high-throughout device may benet from a greater clock rate. The options are
Default, 0020h, 0040h, 0060h, 0080h, 00A0h, 00C0h, and 00E0h. For Unix,
Novelle and other Operating Systems, please select the option: other. If a drive
fails after the installation of a new software, you might want to change this setting
and try again. A different OS requires a different bus master clock rate.
IDE RAID Mode (Available on the Onboard PCI IDE Submenu.)
This feature allows you to set the IDE RAID Mode. The default setting is ATA/
ATAPI.
PCI-E x1 Slot
Access the submenu for each of the settings above to make changes to the
following:
PCI Express Port#1
Select Enabled to always enable PCI-Ex1 Port#1. Select Disabled to disable
PCI-Ex1 Port#1 and all other PCI-E ports. When set to Auto, PCI-Ex1 Port#1
will be enabled if a PCI add-on card is detected. The options are Auto, Enabled
and Disabled.
Option ROM Scan
When enabled, this setting will initialize the device expansion ROM. The options
are Enabled and Disabled.
Enable Master
This setting allows you to enable the selected device as the PCI bus master.
The options are Enabled and Disabled.
Latency Timer
This setting allows you to set the clock rate for the bus master. A high-priority,
high-throughout device may benet from a greater clock rate. The options are
Default, 0020h, 0040h, 0060h, 0080h, 00A0h, 00C0h, and 00E0h. For Unix,
Novelle and other Operating Systems, please select the option: other. If a drive
fails after the installation of a new software, you might want to change this setting
and try again. A different OS requires a different bus master clock rate.
PEG (PCI-Express Graphics) Port Submenu
Access the submenu for each of the settings above to make changes to the
following: