Filter
Top Products
Getting Started 1 - 4
Connecting Power (if required)
If the host does not provide power to the digital imager scanner, connect an external power supply to the digital
imager scanner:
1. Connect the interface cable to the bottom of the digital imager scanner, as described in Installing the
Interface Cable on page 1-3.
2. Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
3. Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply
into an AC outlet.
Configuring the Digital Imager Scanner
To configure the digital imager scanner, use the bar codes included in this manual, or the 123Scan
configuration program.
See Chapter 4, User Preferences & Miscellaneous Digital Imager Scanner Options and Chapter 5, Imaging
Preferences for information about programming the digital imager scanner using bar code menus. Also see
each host-specific chapter to set up connection to a specific host type.
See Chapter 9, 123Scan to configure the digital imager scanner using this configuration program. A help file is
available in the program.
Mounting the Digital Imager Scanner
Desk Mount
Use the optional desk mount for convenient and protective placement of the digital imager scanner on a flat
surface. Simply place the mount on the surface. The rubber feet hold the mount securely in place when
inserting and removing the digital imager scanner.
Figure 1-4
Inserting the Digital Imager Scanner in the Desk Mount
The desk mount can also be secured to a desk surface by inserting two screws* appropriate for the mounting
surface through the screw holes of the desk mount, and into the surface. The desk mount can be screwed onto
the surface with or without the rubber feet.
*The recommended screws are two #6 screws (5/8” long).