Filter
Top Products
2 - 2 DS6707 Digital Imager Scanner Product Reference Guide
Beeper Definitions
The digital imager scanner issues different beep sequences and patterns to indicate status. Table 2-1 defines
beep sequences that occur during both normal scanning and while programming the digital imager scanner.
Table 2-1
Beeper Definitions
Beeper Sequence Indication
Standard Use
Low/medium/high beeps Power up.
Short high beep A bar code symbol was decoded (if decode beeper is enabled).
4 long low beeps A transmission error was detected in a scanned symbol. The data is ignored. This
occurs if the digital imager scanner is not properly configured. Check option setting.
5 low beeps Conversion or format error.
Low/high/low beeps ADF transmit error. See Chapter 11, Advanced Data Formatting.
High/high/high/low beeps RS-232 receive error.
Parameter Menu Scanning
Short high beep Correct entry scanned or correct menu sequence performed.
Low/high beeps Input error; incorrect bar code, programming sequence, or Cancel scanned;
remain in ADF program mode.
High/low beeps Keyboard parameter selected. Enter value using numeric bar codes.
High/low/high/low beeps Successful program exit with change in parameter setting.
Low/high/low/high beeps Out of host parameter storage space. Scan Set Default Parameter on page 4-4.
Code 39 Buffering
High/low beeps New Code 39 data was entered into the buffer.
3 long high beeps Code 39 buffer is full.
Low/high/low beeps The Code 39 buffer was erased or there was an attempt to clear or transmit an empty
buffer.
Low/high beeps A successful transmission of buffered data.
Macro PDF
2 long low beeps
File ID error. A bar code not in the current MPDF sequence was scanned.
3 long low beeps Out of memory. There is not enough buffer space to store the current MPDF symbol.
4 long low beeps Bad symbology. Scanned a 1D or 2D bar code in a MPDF sequence, a duplicate
MPDF label, a label in an incorrect order, or trying to transmit an empty or illegal MPDF
field.
5 long low beeps Flushing MPDF buffer.