Filter
Top Products
User guide Menu
49
Setting parameters
(principle)
Before you begin setting the parameters, you should check which pa-
rameters your system requires. Furthermore it is recommended to print
out the status page which contains the actual valid parameter values
(see Printing out the status page, page 53).
The start values, which are activated after switching on or after error
correction, are determined using the adjustable printer parameters. In
many cases these parameters are overwritten by means of a system ap-
plication.
Changed parameter settings are stored when the settings menu is quit-
ted and retain their values even when the printer is switched off.
Make sure that the printer is in menu mode (see section Calling up the
menu, page 46).
Press the EJECT key to select next main menu or press the USER key
to select a previous main menu.
Press the STOP key to enter to the Parameter select mode. The LCD
displays the respective parameter and MENU.
Press the EJECT key to select a next parameter or press the USER key
to select a previous parameter.
Press the STOP key to enter the MENU setting mode.
EJECTUSER
SET UP
1
2
STOP
EJECTUSER
SET UP
1
2
STOP
EJECTUSER
SET UP
1
2
STOP
EJECTUSER
SET UP
1
2
STOP