Filter
Top Products
TANDBERG Gatekeeper User Guide
Page 20 of 105
4.4. IP Configuration
The Gatekeeper may be configured to use IPv4, IPv6 or both protocols. If using both protocols, the
Gatekeeper will act as a gateway if necessary, allowing calls to be made between an IPv4-only endpoint
and an IPv6-only endpoint. This behavior will use a traversal license for each call gatewayed between
IPv4 and IPv6.
IPv4 and IPv6 dual stack behavior is controlled by the command:
xConfiguration IPProtocol: <Both/IPv4/IPv6>
or using the web interface via System Configuration > IP Configuration shown in Figure 3 below:
Figure 3: Selecting IP Protocol
4.5. Endpoint Registration
Before an endpoint can use the Gatekeeper it must first register with it.
There are two ways an endpoint can register:
Automatically
Manually by specifying the IP address of the Gatekeeper.
Note: You can disable automatic registration on the Gatekeeper. See the Auto Discovery command
(section 16.2.4) for more information.