Filter
Top Products
TANDBERG Gatekeeper User Guide
Page 67 of 105
To upgrade using SCP or PSCP:
1. Make sure the system is turned on and available on IP.
2. Upload the release key file using SCP/PSCP to the /tmp folder on the system e.g.
scp release-key root@10.0.0.1:/tmp/release-key or
pscp release-key root@10.0.0.1:/tmp/release-key
3. Enter password when prompted.
4. Copy the software image using SCP/PSCP. The target name must be /tmp/tandberg-
image.tar.gz, e.g.
scp s42000n51.tar.gz root@10.0.0.1:/tmp/tandberg-image.tar.gz or
pscp s42100n51.tar.gz root@10.0.0.1:/tmp/tandbergimage.tar.gz
5. Enter password when prompted.
6. Wait until the software has installed completely. This should not take more than two minutes.
7. Reboot the system.
After about four minutes the system will be ready to use.