Filter
Top Products
TANDBERG Gatekeeper User Guide
Page 85 of 105
16.3.7. CredentialDelete
xCommand CredentialDelete <index>
Deletes the indexed credential.
16.3.8. DefaultLinksAdd
xCommand DefaultLinksAdd
Restores the factory default links for bandwidth control.
16.3.9. DefaultValuesSet
xCommand DefaultValuesSet Level <level>
Resets system parameters to default values. Level 1 will reset most parameters. There are currently no
level 2 parameters, so setting that level has the same effect as setting level 1. Level 3 resets all level 1
and 2 parameters as well as the following:
IP address, subnet mask, gateway and interface speed. The default IP address is
192.168.0.100.
COM port baud rate, speed, data bits, parity, stop bits
SNMP community name and host address
system name
password
option key
release key
Note: DefaltValuesSet will not add the links with which the system ships from the factory. Use the
DefaultLinksAdd command to do that. Certificates and policy files are not removed.
16.3.10. DenyListAdd
xCommand DenyListAdd <denied_alias>
Add an entry to the deny list. This is used by the registration restriction policy.
denied_alias can either be a specific alias, or use the wildcards ? (for a single character) and * (for
a single character or string of characters) to pattern match a group of possible aliases.
16.3.11. DenyListDelete
xCommand DenyListDelete <index>
Removes the pattern with the specified index from the deny list.
Deny list entries can be viewed using the command xconfiguration Gatekeeper
Registration DenyList.