Filter
Top Products
TANDBERG Gatekeeper User Guide
Page 52 of 105
12.3.2. Enabling call transfer
To enable call transfer, either:
issue the command:
xConfiguration Services CallTransfer Mode: <On/Off>
or go to Gatekeeper Configuration -> Services and in the Call Transfer section, tick the Allow call transfer
box (see Figure 23).
Figure 23: Enabling call transfer
12.4. Disconnecting a Call
An existing call may be disconnected using the Gatekeeper by issuing the command:
xCommand DisconnectCall: <index>
where:
index
the call index as reported by xStatus Calls