Filter
Top Products
Operating Basics
6
P6434 Probe Instructions
Disconnecting the P6434 Probe from the SUT
To disconnect the P6434 probe, follow these steps:
1. Gently pull the latch release grip to release the probe tip from the latch
housing as shown in Figure 5.
Grasp sides
and gently pull
Latch release grip
Figure 5: Releasing the probe tip from the latch housing
CAUTION. To avoid damage to the probe and mating connector, hold on to the
latch release grip and gently pull the probe straight out of the connector. Do not
tilt the probe in any direction when disconnecting it. Tilting the probe can
damage the probe and mating connector.
2. Continue to gently pull the probe tip straight out of the mating connector
using the latch release grip.
If you are using an extender, grip the corners of the circuit board end
attached to the SUT, and gently pull it straight out of the connector.